A torsion spring must match the door's weight, height and track setup, so a technician measures the old spring and the door before fitting a new one. Guessing at sizes leaves the door unbalanced. Call the number on this page to be connected with a local garage door company in Jonestown.

Signs the shaft springs are done
- A visible split or gap in the coil
- A bang followed by a door that will not lift
- Cables hanging loose on the drums
- A door that drifts down when raised partway
If you spot any of these, leave the door alone and call.
The center bearing question
Some shafts have a center bracket with a bearing, and doubled springs share it. The technician checks that the bearing, end bearings and shaft are straight and free-turning before fitting new springs. Worn bearings can squeal and make a fresh spring wear unevenly.
On a sloped lot around Cedar Park, the garage floor can slant, so ask the technician to check the door's balance after the springs go in.
Damp air near the water encourages rust on exposed coils, so springs on lakeside homes may wear faster than those inland, and the shaft hardware deserves a look.
Cycle life explained
A cycle is one full open and close. Springs are made to a rated number of cycles, and standard ones suit an average household, while longer-life versions use heavier wire or longer coils to last more openings. A door used constantly may benefit from the higher rating.
Q: Is it worth upgrading the springs?
A: It depends on use. A busy household with many daily trips may find longer-life springs worthwhile. An occasional-use garage may not. The technician can explain the difference and what it means for your door.
Why this is not a DIY job
A torsion spring stores a great deal of force, and winding bars can slip or kick. Serious hand, arm and face injuries are well known in the trade. This page gives no steps for the repair, because the safe answer is a trained technician with the right tools.
Before work starts in Jonestown
Federal rules (16 CFR part 1211) require residential openers to reverse when they hit something and to come with a secondary device such as photo-eye sensors, so a door that won't reverse needs attention before anyone uses it again.
Planning a new door? If an HOA covers your street, its architectural review may need to sign off on style and color first; repairs that keep the same look usually don't.
Jonestown Development Services handles building permits for Jonestown addresses; a like-for-like door swap often needs nothing, while framing changes may.
No power, no opener. Your electric bill lists the outage number, and the red release cord lets you lift the door manually, as long as the springs aren't broken.
Calls from Jonestown are often matched with companies that also cover Cedar Park, Lago Vista and Hudson Bend.
Torsion Spring Replacement questions in Jonestown
How do I know my door has torsion springs?
What happens to the cables when a spring breaks?
Does replacing springs void a door warranty?
Are lake garages harder on springs?
More garage door services in Jonestown
Torsion Spring Replacement nearby
Helpful guides
Sources
Last updated: