A broken spring is the one garage door problem where the safest move is to do less. This guide covers how to recognize a failed spring, what to do in the first few minutes, and what a repair usually involves.
The short version
If you think a spring has broken, leave the door closed, stop using the opener, keep people and cars out of the door's path, and call a professional. DASMA, the garage door industry association, says spring systems are dangerous and should be repaired only by trained professionals. It also notes that extension springs are under high tension when the door is down. That tension is why this is not a weekend project, however many videos make it look simple.
This site is a free referral service, not a garage door company. When you call the number on a page here, you are connected with an independent local garage door company that can talk through the repair and quote it.
How to tell a spring has broken
Most homeowners in the Austin area describe the same few things. You hear a loud bang from the garage, sometimes strong enough that people assume something fell off a shelf. Afterward the opener hums or strains and the door barely moves, or it rises a few inches and drops. The door may feel extremely heavy if you try to lift it, or it may sit crooked in the opening. With a torsion spring, you may see a visible gap in the coil on the bar above the door. With extension springs along the side tracks, one may be stretched out or lying loose.
A door is balanced by its springs. The opener is only a motor that guides the door along, and most openers are not built to lift the full weight. If a spring has let go, the opener ends up doing work it was never meant to do, which can burn out the motor or strip the drive gear.
What to do in the first few minutes
- Leave the door where it is. Do not try to raise it by hand to get a car out.
- Stop pressing the wall button and the remote. Each attempt loads the opener and the door's hardware.
- Keep children and pets out of the garage, and move vehicles away from the door's path if you can reach them safely.
- Do not use the red emergency release cord. DASMA's guidance says that if a spring is broken, the door should not be operated until the spring is replaced, and a released door with no spring support can drop fast.
- Take a photo of the springs and any visible damage so you can describe it on the phone.
If the door is stuck open, the same advice applies: do not walk under it, and do not lower it by hand. A door that is partly raised on a failed spring is heavier than it looks.
What not to do
Do not try to unwind, loosen, remove or reinstall a spring, a cable or a bottom bracket yourself. These parts hold the door's weight under load. DASMA says cables should be replaced only by a trained technician because of the high spring tension, and the bottom brackets are connected to those same cables. This guide will not walk you through any of it, and you should be wary of any source that does. If you want to understand more about how the parts relate, the garage door spring repair page explains the system without telling you to touch it.
What a spring repair usually involves
When you call, expect questions about the type of spring, the size and weight of the door, whether it is a single or double garage, and whether anything else looks damaged. Most steel sectional doors in Central Texas use torsion springs mounted on a bar above the door. Older doors and some budget installs use extension springs along the tracks. The torsion spring replacement and extension spring repair pages describe each type.
A company should size replacement springs to the door rather than guessing. Ask how they match a spring to your door, whether the quote lists parts, and what warranty the spring manufacturer gives. Springs are rated for a set number of open-and-close cycles, and a door that gets used many times a day wears through them sooner. A single broken spring often means its partner is close behind, so it is common to hear that both should be replaced together. That is a fair question to ask about, not something to accept or reject without a reason.
A snapped spring can also damage other parts. A cable may have slipped, a drum may be cracked, or the door may be crooked in its tracks. If so, the work grows beyond the spring. See garage door cable repair and off-track garage door repair for those problems, and broken garage door repair for the overall picture.
What it costs
These are national figures, not an Austin price list. HomeGuide puts replacing two torsion springs at roughly $200 to $350, and a single torsion spring at $140 to $270. Extension springs run lower, about $150 to $200 for two. Replacing a spring and cable together is listed at about $200 to $500, and cable replacement alone at $80 to $185. Actual quotes depend on the door's weight, spring size, hardware condition and the company you call. Use these only as a rough check on whether a quote is in a believable range. The garage door repair cost guide covers Austin figures for a wider set of jobs.
Why springs fail in Central Texas
Springs are wear parts, and they do not last forever. In Austin, summers are long and hot. NWS puts the average first 100-degree day on July 9th and the average last on August 21st, with the peak in early August. A west-facing garage with no insulation can get far hotter than the air outside. Heat dries out lubricant, and dry springs and rollers work harder. Many owners never lubricate anything, and many doors in older subdivisions are well past the cycle count the original springs were built for. The Texas heat guide goes further into what heat does to a door.
Check these before you assume it is the spring
A few look-alike problems are safe for an owner to rule out, and doing so can save a call. Check that the wall-button lock switch is not engaged, since it blocks remotes. Replace remote batteries. Look at the sensor lenses near the floor for dirt or a misaligned light, a point covered in the garage door won't close guide. If the opener hums but the door does not move at all, the spring is the likelier cause. If the opener does nothing, it is probably a power or control problem; see garage door opener repair.
If the door is down and the springs look intact (no visible gap, nothing stretched or loose), the red release cord is the one owner-operated step covered in the power outage guide. If you are not sure the springs are intact, do not use it.
Calling after hours
Many garage door companies take after-hours calls, so ask when you call. A closed door with a broken spring is a stable situation. The door is not going anywhere, and waiting until a company can schedule properly is usually better than rushing into any improvised fix. If your car is stuck inside, that is frustrating, but it is not a reason to force the door.
After the repair
Once a new spring is in, the door should feel balanced and the opener should run without strain. Run the monthly garage door safety test, including the 2x4 reversal check, and ask the company what maintenance they recommend. A garage door tune-up from time to time keeps springs, rollers and hinges lubricated, and in hot climates that helps. If you want to compare companies first, read hiring a garage door company before you call anyone back.
You can also find a page for your own town through the service areas list, which covers Austin and nearby towns across Travis, Williamson, Hays, Bastrop and Caldwell counties.
Frequently asked questions
Can I open a garage door with a broken spring?
Why did my opener stop lifting the door?
Should both springs be replaced at once?
How much does a spring replacement cost?
Is it safe to use the emergency release with a broken spring?
Sources
Last updated: