Garage door sensors are the small eyes near the floor on each side of the door, and when they are blocked, dirty or out of line the opener will not close the door. Some fixes are simple owner checks. Call the number on this page to be connected with a local garage door company in Austin.

What the safety sensors do
Federal rules under 16 CFR part 1211 require a secondary entrapment device on residential openers, and a photoelectric sensor that is triggered while the door is closing must make it reverse and fully reopen. The pair of sensors sit a few inches off the floor, one on each side of the opening, and send an invisible beam across it. When something breaks that beam, the door stops or goes back up.
Signs a sensor needs attention
- The door starts down, then reverses before it reaches the floor.
- The opener lights blink but the door will not close from the remote or wall button.
- One sensor light is off, dim or flickering.
- The door closes only if you hold the wall button down.
- Wires near the sensors are cut, chewed or pulled loose.
Owner checks that are safe
With the door fully open or fully closed, wipe both lenses with a soft cloth and clear away cobwebs, leaves and stored items. In Central Texas, dust from limestone soils and afternoon sun glare on west-facing garages cause plenty of false stops. Check that each sensor still points at the other and has not been knocked by a bumper or a bike. Do not bypass or disable sensors, and do not pull the door down by hand if a spring may be broken.
What happens on the call
This is a free referral service, not a garage door company. The number on this page connects you with an independent local garage door company serving Austin. Tell them your opener brand if you know it, what the lights are doing and what you have already tried. Ask for a written quote that lists parts and labor.
What sensor repair costs
National figures from HomeGuide put sensor repair at $85 to $100, while Inch Calculator lists $110 to $200. An Austin cost guide from HomeAdvisor puts general garage door repair at $125 to $290. Wiring damage or an older opener can raise the total.
Test reversal after any repair
CPSC advises laying a 2x4 flat on the floor in the door's path. If the door does not reverse when it touches the board, disengage the opener until it is adjusted, repaired or replaced. Sensors and reversal are separate protections, so test both, and keep remote controls away from children.
Garage Door Sensor Repair questions from Austin homeowners
Why does my garage door reverse before it closes?
Can I bypass the sensors to close my door?
Do sensors fail more in Austin summers?
Is a sensor problem the same as a broken spring?
Related garage door services in Austin
Helpful guides
Garage Door Sensor Repair in nearby cities and towns
Travis County
Williamson County
Hays County
Bastrop County
Caldwell County
Sources
- eCFR: 16 CFR Part 1211, Safety Standard for Automatic Residential Garage Door Operators
- CPSC: Garage Door Opener Safety Advice
- HomeGuide: How Much Does It Cost To Repair A Garage Door?
- Inch Calculator: Cost to Repair a Garage Door - 2026 Price Guide
- HomeAdvisor: How much do garage door repair services typically cost? (Austin, TX)
Last updated: